Teknobond 250 Industrial PVC Floor Adhesive

Product description
It is an acrylic-based, water-based, high-adhesive, new generation PVC and linoleum floor coating adhesive.

Usage areas
• Hospitals, laboratories, residences, shopping malls,
• PVC, PU, ​​latex backed flooring,
• Marley, marmelium, linoleum,
• Homogeneous and heterogeneous floor coverings,
• Bonding applications of PVC, PU and latex coated carpets,
• In surface coatings that are flexible and insulated with textiles,
• On ready flat and absorbent surfaces,
• It is used for bonding carpet, PVC coating materials to concrete and screed.
 
Features and Advantages
• Easy to apply.
• Long operating range and high strength.
• Solvent free.
• It gives high performance in first and final adhesion.
• Suitable for floors with underfloor heating.
• Resistant to wheelchair load.

Application Instructions
Surface Quality: The application surface must be cleaned from substances that prevent adhesion such as dust, oil, pitch, detergent and mold oil. Loose parts in the application area should be removed and the surface should be cleaned with a compressed air compressor or vacuum.

Surface Preparation: If there are voids, swelling and precipitation (undulation) on the ground, the surface should be leveled using TEKNOSELF or TEKNO-SELF 500. Depending on the ground condition, priming can be done with TEKNOLATEX 200 if necessary.

TEKNOBOD 250 is applied to the surface with a saw-toothed trowel. Consumption is adjusted according to the tooth depth of the trowel. After TEKNOBOND 250 is applied to the surface, the PVC coating is adhered to the surface within 2-3 minutes without forming an adhesive film layer. After adhesion is achieved, it is ensured that it adheres well by applying pressure for a short time.

Application Notes / Limitations
• For floors with underfloor heating, the heating system should be started 10 days before the coating and turned off during the coating.
• For optimum operation, the floor temperature should be between (+) 18 °C (+) 25 °C.
• The heater can be started again 72 hours after laying.
• The layer that may form on the surface during a long storage should be discarded before starting to use.
• All equipment used, immediately after the application, before it hardens; should be cleaned with hot water. The cured product can only be cleaned mechanically.
• Hands should be washed with warm water and soap.
• Contact with eyes should be avoided.