Teknolatex 300 Adherence Primer on Ceramic

High viscosity, acrylic emulsion based, single component primer with high adhesion and water impermeability.

Usage areas
• On vertical, glassy surfaces or ceramics,
• Primer for sticking ceramic on ceramic,
• It is applied to increase adherence and decrease the absorbency of the surface.

Features and Advantages
• Ready to use, easy and fast to apply.
• It is water-based, odorless and can be used safely indoors.
• It has high adhesion strength.
• It is applied before cement and gypsum based coatings and prevents rapid water loss of the mortar.
• It has high resistance to humidity.
• It has high water impermeability thanks to the special polymers it contains.

Application Instructions
The surface is solid, free of loose and loose parts, free of frost, cement slurry, pond water, oil, grease, paraffin, coatings, etc. impurities and other contaminants must be removed and clean. The surface must be prepared by suitable mechanical preparation techniques such as high pressure water or abrasive equipment. All dust, loose and easily crumbled materials should be completely removed before application, preferably with a brush and/or vacuum. The surface must be dry.

Mix with a low speed mixer for at least 3 minutes in a clean container free of all kinds of non-adhesive substances or in its own package.

It is applied to the surface with the help of a brush or roller. A single layer application is made.

Application Notes / Limitations
• The product may cause irritation in contact with the skin. Work clothes, protective gloves, masks and goggles should be used. Before starting work, a protective cream can also be applied to the hand. In case of contact with the eyes, the eyes should be immediately washed with warm water and a doctor should be consulted.
• Do not add foreign matter.
• Pre-testing is recommended for different applications.
• It cannot be used as a stand-alone waterproofing material.
• After the application, it should be protected against adverse weather conditions such as direct sunlight, strong wind, high air temperature (over +35 °C), rain and frost. Before the product is fully cured and hardened, hands should be cleaned with water and detergent.